Allied Data Technologies 811 Manual de Instalação descarregar pdf (Página 77)

Chapter 5: Configuring the CopperJet

5.19 DSL Line

The DSL Port menu allows you to configure specific DSL settings. Usually, the default

settings are sufficient to make a good DSL connection. Only for fine-tuning or advanced

administration, the DSL port menu brings useful information.

From the Configuration menu, go to Ports and click on DSL. The DSL Port Configuration

page is displayed.

This page provides the following information.

Connected: Shows if your DSL line is up (true) or not (false).

Operational Mode: The modulation type used to make the connection. Advice:

set the ADSLMode (line modulation) on Multimode.

State: Shows the status of the line: Handshake, Training or

Showtime.

Tx Bit Rate: The maximum Transmit Bit Rate of your DSL line.

Rx Bit Rate: The maximum Receive Bit Rate of your DSL line.

Activate Line: None: DSL link will not be activate.

Abort: Deactivate the DSL link.

Start: Activate the DSL link

Whip: Propriarity protocol, disabled by default.

Standard: Multimode at default.

Ec Fdm Mode: FDM at default.

Annex Type: Shows which Annex Type you have.

Default: None at default.

Page 75

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 85 86

Sem comentários

Allied Data Technologies 811 Manual de Instalação Página 77